On December 16, 2016, China Science and Technology (Beijing) Scientific and Technological Achievements Evaluation Center, in accordance with the relevant provisions of the "Science and Technology Evaluation Methods" of the Ministry of Science and Technology, adhered to the principle of scientific, objective, independent, and fair , Organized experts in the Institute of Physics, Chinese Academy of Sciences, and conducted scientific and technological achievements evaluation on the “Key Technology R&D and Application of Flame Retardant, Smoke-Suppressing, and Lightweight Wood-plastic Decorative Materials” developed by Wenzhou Shangju Environmental Protection Technology Co., Ltd. Secretary-General of the China Flame Retardant Society, Professor Zhou Zhengyu of Beijing Institute of Technology, Professor Menggen University of Beijing University of Chemical Technology, Professor Hu Ping of the Department of Chemical Engineering, Tsinghua University, Professor Zhang Shuangbao, School of Materials Science and Technology, Beijing Forestry University, Research Fellow of the Institute of Fire Protection, Chinese Academy of Science and Technology, Ma Daozhen, China Gao Shiheng, professor-level senior engineer of the Association for Comprehensive Utilization of Resources, and Jin Shi, a researcher of the New Materials Professional Committee of the Chinese Chemical Society, attended the meeting.
After expert review, the project was found to have been tested by the national fixed fire extinguishing system and the quality supervision and inspection center of fire-resistant components. The wood-plastic products manufactured using this technology reached the mandatory national standards: GB8624-2012 (B1 flame retardant standard) and GB/T8627 -2007 (Smoke Density Rating Standard); The quality of indoor formaldehyde emission of wood-plastic products manufactured by this technology is 0.3 mg/L, as measured by the National Chemical Building Materials Quality Supervision and Inspection Center, reaching the national environmental protection standard (GB24137-2009); The density of the wood-plastic products manufactured by the project is only 0.53 g/cm3, which meets the requirements of lightweight building materials. At the same time, the results of this project are of the same level of advanced technologies in the country, and the flame retardancy, smoke suppression, extrusion foaming and surface modification technologies have reached the domestic level. Leading technology in its class. The participating experts unanimously agreed to pass the evaluation of scientific and technological achievements. (Reporter: International Business Daily Liu Ping)
The article was taken from:http://www.cctvblzg.com/special/shownews.php?lang=cn&id=94